• 船舶动力装置题库

Additives () protective layers on metal

[单选题]Additives () protective layers on metal surfaces guarding them against corrosion.A . damageB . formC . dissolveD . contaminate

  • 查看答案
  • 桨叶平均螺距为桨叶上各半径截面的()的算术平均值。

    [单选题]桨叶平均螺距为桨叶上各半径截面的()的算术平均值。A . 局部螺距B . 截面螺距C . 总平均螺距D . 平均螺距

  • 查看答案
  • () or air venting arrangement is fitted

    [单选题]() or air venting arrangement is fitted to the fuel supply passage.A . An air pumpB . A compressorC . A fuel pumpD . A priming

  • 查看答案
  • 舵杆上()的纵向裂纹可焊补修理。

    [单选题]舵杆上()的纵向裂纹可焊补修理。A . 长度<1/4公称直径、深度<10%公称直径B . 长度<1/5公称直径、深度<10%公称直径C . 数量不超过2条且不在同一条直线上D . 数量不超过4条

  • 查看答案
  • 依螺旋桨桨叶上某半径截面上的局部螺距可计算出()。

    [单选题]依螺旋桨桨叶上某半径截面上的局部螺距可计算出()。A . 桨叶螺距B . 截面螺距C . 总平均螺距D . 部分螺距

  • 查看答案
  • 怎样测量轴承间隙?

    [问答题] 怎样测量轴承间隙?

  • 查看答案
  • () providing lubricating films, oil used

    [单选题]() providing lubricating films, oil used in marine diesel engines have to remove heat from oil cooled piston.A . Except forB . BesideC . ExceptD . In addition to

  • 查看答案
  • () usually helps to induce air movement

    [单选题]() usually helps to induce air movement to assist combustion.A . Cylinder coverB . Main bearingC . The exhaust valveD . The piston movement

  • 查看答案
  • 舵系中心线与轴系中心线应该()。

    [单选题]舵系中心线与轴系中心线应该()。A . 垂直B . 相交C . 平行D . 重合

  • 查看答案
  • At least () cylinders in four-stroke eng

    [单选题]At least () cylinders in four-stroke engine will be configured to ensure that the engine can be started with the crankshaft at whatever position.A . 6B . 2C . 12D . 8

  • 查看答案
  • () at the end of the distribution pipe e

    [单选题]() at the end of the distribution pipe ensures that adequate pressure is maintained by the pump.A . A relief valveB . An alarmC . A pressure gaugeD . A non-maim valve

  • 查看答案
  • 如何对气缸盖裂纹进行修理?

    [问答题] 如何对气缸盖裂纹进行修理?

  • 查看答案
  • () is used for cylinder and cylinder hea

    [单选题]() is used for cylinder and cylinder head, the salt water is used for cooling the lubricating oil, the fresh water in the coolers and the charging air in the air cooler.A . The fuel oilB . The lube oilC . The sea waterD . The fresh water

  • 查看答案
  • 如何对活塞杆填料函进行检修?

    [问答题] 如何对活塞杆填料函进行检修?

  • 查看答案
  • 舵系中心线与轴系中心线应相交,其位置度偏差不得超过()m(L为船长,m)。

    [单选题]舵系中心线与轴系中心线应相交,其位置度偏差不得超过()m(L为船长,m)。A . 0.001L1/3B . 0.01L1/3C . 0.1L1/3D . L1/3

  • 查看答案
  • 怎样防止曲柄箱爆炸?

    [问答题] 怎样防止曲柄箱爆炸?

  • 查看答案
  • 螺旋桨桨叶面上的B区是指()的区域和A区两侧边缘、吸力面0.7R以内范围。

    [单选题]螺旋桨桨叶面上的B区是指()的区域和A区两侧边缘、吸力面0.7R以内范围。A . 0.3~0.5RB . 0.4~0.7RC . 0.5~0.8RD . 0.6~0.9R

  • 查看答案
  • () device is provided to prevent startin

    [单选题]() device is provided to prevent starting air from being admitted to the cylinder before the reversing is completed.A . An automaticB . A transmissionC . A self-regulatingD . An interlocking

  • 查看答案
  • A-frames are mounted on the bed plate an

    [单选题]A-frames are mounted on the bed plate and support () and cylinder block.A . the main bearingB . the cylinder coverC . the entablatureD . the sum

  • 查看答案
  • 转舵不准,舵角不正可能是()。

    [单选题]转舵不准,舵角不正可能是()。A . 舵杆折断B . 舵叶进水C . 舵杆变形D . 舵承间隙过小

  • 查看答案
  • A high temperature alarm or () which wil

    [单选题]A high temperature alarm or () which will melt is used to guard against the explosion of compressor air pipelines.A . a flame trapB . a relief valveC . a fusible plugD . a bursting ca

  • 查看答案
  • 如何防止柴油机拉缸?

    [问答题] 如何防止柴油机拉缸?

  • 查看答案
  • 航行中在舵机工作正常的情况下,舵沉重的原因可能是()。

    [单选题]航行中在舵机工作正常的情况下,舵沉重的原因可能是()。A . 舵杆变形B . 舵承损坏C . 舵系安装不良D . 舵杆折断

  • 查看答案
  • 对偶件的磨损怎样检验?

    [问答题] 对偶件的磨损怎样检验?

  • 查看答案
  • 船舶开航前的备车应做哪些工作?

    [问答题] 船舶开航前的备车应做哪些工作?

  • 查看答案
  • 静平衡试验后,较轻桨叶上的挂重大于允许值,则应铲去()附近金属。

    [单选题]静平衡试验后,较轻桨叶上的挂重大于允许值,则应铲去()附近金属。A . 较重桨叶叶背边缘B . 较重桨叶叶面边缘C . 较轻桨叶叶背边缘D . 较轻桨叶叶面边缘

  • 查看答案
  • 加热温度在()以下进行的校正为冷态校正。

    [单选题]加热温度在()以下进行的校正为冷态校正。A . 室温B . 0℃C . 150℃D . 250℃

  • 查看答案
  • 反映舵杆轴颈磨损的指标有()。

    [单选题]反映舵杆轴颈磨损的指标有()。A . 圆度、圆柱度B . 圆柱度、椭圆度C . 椭圆度、锥度D . 锥度、圆柱度

  • 查看答案
  • 舵系振动的原因可能是()。

    [单选题]舵系振动的原因可能是()。A . 舵承间隙过小B . 舵承间隙过大C . 舵杆变形D . 舵杆折断

  • 查看答案
  • A diesel engines crankcase oil level is

    [单选题]A diesel engines crankcase oil level is found to be too high√ You should suspect that ().A . the engine was over filledB . there might be a fuel leakC . there might be a water leakD . all of the above

  • 查看答案